11/16/2023 0 Comments Sticky putty epoxy![]() READY TO PRIME IN 30 MINUTES After wiping dry, wait for 30 minutes, then apply Jenolite Primer or topcoat. Wipe dry immediately with a clean lint-free cloth. Leave until the rust has been removed, drain excess liquid for one minute. To ensure all rust has been successfully removed, brush away the dark grey residue with a wire brush/steel wool (if rust is still present thereafter, repeat the process as above until all rust has been removed).įOR IMMERSION Small components can be immersed in a plastic container. Continue this process until all visible rust has turned dark grey in colour, at which point, wipe the surface dry with a clean, lint-free cloth. Vertical surfaces may require the most attention. Do not allow the surface to dry out or become tacky. Keep Jenolite active by working in with a brush every 5 minutes and adding more if required. Brush liberally, directly onto rusty areas only. Remove old paint and loose rust with steel wool or wire brush.ĪPPLY DIRECTLY TO RUST Pour the required amount into a plastic container. Full functional after 60 mins, once fully cured it is completely waterproof and can be drilled, tapped, machined, ground, filed and even painted. Ideal for marine repairs and repairs to damp, wet and underwater surfaces, such as holes, cracks, leaks and gouges in decks and hulls, swimming pools, hot tubs, spas, recreational equipment, as well as leaking tanks and gutters. After mixing, the epoxy resin forms a polymer compound that may be applied underwater (either fresh or salt water) and will bond tenaciously to substrates such as fiberglass, concrete.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |